|
Title: Properties of ASENBUS Post by: Chris on 09 Dec 2004, 20:16 Hi,
I was wondering if anybody can explane when and how ASENBUS becomes active and what its perpose is? From looking at the code it seams to be active low! but I think I must be mistaken. Does it go high the moment the HU is switched on or only when the CDMC is selected. Cheers Chris Title: Properties of ASENBUS Post by: Vitat on 09 Dec 2004, 21:21 ASENBUS is set to 12 volt when ACC is powered and front panel is set on HU.
If you detouched front panel or turn OFF the ACC - ASENBUS is set to ground. Title: Properties of ASENBUS Post by: Chris on 11 Dec 2004, 19:22 Cheers!
Does this mean that ASENBUS goes low when you select radio etc? if not, does the HU send a stop signal to the CDMC? Title: Properties of ASENBUS Post by: Vitat on 12 Dec 2004, 19:55 No. ASENBUS not goes low when you select radio.
HU send stop signal throw IP-Bus. |