|
Title: lm339 resistor values Post by: cyclonite on 16 Jun 2005, 19:13 hello vitat...
Is it possible to changes the values 10Kohm to 1Kohm and the 1Mohm to 100Kohm thus keeping the amplification at 100 times... or would it put too much strain on the ip-bus / can driver? thank you.. Title: Re: lm339 resistor values Post by: Vitat on 17 Jun 2005, 01:31 No. You must use 10k resistor. I found this nominals experimentaly. But it possible dont using 1M resistor, this resistor usied only for stability.
Title: Re: lm339 resistor values Post by: cyclonite on 17 Jun 2005, 02:23 U use the feedback network with the 1 Mohm for stability?
isn't a schmitt trigger configuration a better solution? Title: Re: lm339 resistor values Post by: Vitat on 18 Jun 2005, 01:32 1MOhm used for hysteresis.
|